Unless your floor is flat and even, it is highly unlikely that you can hang a door on your own. However, it doesn’t hurt to know the high spot on the floor to level the door properly. Bryan Harrell of Northwest Exteriors explains how to hang a door. Listed below are some basic steps that you can follow to hang a door. After you have a basic understanding of how to hang a door, you’ll be ready to tackle the project.
To hang a door, start by checking the hinge side of the jamb. If the door has a pin hinge, make sure that the pin slides back into place after hanging. If the hinge side of the door is loose, score the door with a straight edge and knife. Use the pencil line to avoid tearing out the door, but leave a line so that you can clean the plane. If you accidentally score the door, you can erase the pencil marks with a sanding pad.
If you’re confident with tools, you can try hanging a door on your own. However, it is important to be accurate in your measurements. Before hanging the door, you need to remove the old door slab. Get a second person to help you. You may also need a helper to hold the door against the frame and mark where the handle will be. Then, use a temporary screw to hold the door in place while you mark.
After you’ve marked the location of the hinge flap, you can install it. Before you screw on the hinges, make sure that the frame is flat and the hinge flaps are level. To avoid making the door stick out of place, mark the hinge positions with a pencil. Once you’ve marked the location, install the door with the hinges and test it to ensure it fits properly. If you have any gaps, fill them with sandpaper.
If you’re a handyman, it is a good idea to have the right tools. First, you’ll need a gauge. The gauge should be the same thickness as the hinge itself. The gap between the door and the frame should be the same. If you use a gauge that’s deeper than the gauge, you’ll tighten the gap and loosen the hinge side. If you use a gauge that’s too shallow, the gap will be too wide and the door will bounce open.
Next, you’ll need a drill. Once you’ve marked the hole for the door handle, you’ll need to drill the corresponding holes in the shaft. You’ll need to make sure that you don’t miss any studs, as this will make the door look uneven. Make sure you follow the instructions on the drill bit to avoid splitting wood. Next, you’ll need to place the handle.
